www.slothmud.org

EDITED OUT:

DO NOT COPY SPECIAL CHARACTERS INTO YOUR SCRIPTS. THEY CAUSE SAVE/LOAD ISSUES.

EDITED OUT, DOESN'T WORK.

EDITED OUT, DOESN'T WORK

This won't work for everyone unfortunately. Because the 'special characters' aren't $ ] and [ on all operating systems.

Try this function out. It will work on ALL operating systems. It cuts the end off the string (the 'special character'), reverses the string and cuts off the end again (the other 'special character'). That cleans up the string to be parsed, and returns a table named MSDP. So you can refer to exits and their status' by checking MSDP.North or w/e:

Code: Select all

function parseExits(event,msdp)
  MSDP = {}
  msdp = string.cut(msdp,msdp:len()-2)
  msdp = string.reverse(msdp)
  msdp = string.cut(msdp,msdp:len()-2)
  msdp = string.reverse(msdp)
  msdp = string.split(msdp,", ")
  for k,v in pairs(msdp) do
    msdp[k] = string.split(msdp[k],": ")
  end
  for k,v in pairs(msdp) do
    MSDP[v[1]] = v[2]
  end
  return MSDP
end

I'm using this for a nice looking compass I'll post later on by calling this function in an event handler.

EDITED OUT.

Altering a script in any way will always be less ideal than one that requires nothing at all.

EDITED OUT.

Nothing wrong with your script. In fact, you're doing a great job figuring things out! I only point out that there is a more optimal way of parsing the string that doesn't require a copy/paste.

Very good to know. Thank you!